Microe Mercury II 6000V Manuel d'utilisateur télécharger pdf (Page 33)

Page 11

PurePrecision

™

Tape Scale Installation

By Hand

B6.1.2

Removing/peeling the adhesive liner.

Using a sharp tool or fingernails initiate the

peeling of the adhesive liner from designated

"LEFT END" of the tape scale.

Remove/peel back a short length of about

25mm (1 inch) taking care not to touch the

adhesive or allow any particulate

contamination.

NOTE:

Be careful not to expose the adhesive

liner more than 50mm (2 inches).

Do not peel the blue protective film off at

this time.

B6.1.3

Flip the tape over such that exposed adhesive

surface of the tape scale (surface from which

the adhesive liner was removed) faces the

desired location where the tape needs to

be attached.

Adhesive liner peeled off about

25mm (1 inch) from the designated

“LEFT END”

Section B - PurePrecision

™

Tape Scale Installation

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 66 67

Pas de commentaire

Microe Mercury II 6000V Manuel d'utilisateur Page 33