Microe Mercury II 6000V Manuel d'utilisateur télécharger pdf (Page 15)

Page 15

Section C - Reference

Grounding Instructions -

Mercury II

™

6000

Sensor mounted to a surface that is

grounded through bearings or a poorly-

grounded surface, or mounted to a non-

conducting surface

CC11..22..11

15-pin D-sub connector grounding: The

encoder's connector shell must be in intimate,

electrically conductive contact with the

customer-supplied mating connector, which

must be connected to the controller's ground.

If a customer-supplied shielded cable

connects the encoder to the controller, then

the outer shield on the customer-supplied

cable must be connected to the controller's

ground. The controller must be grounded to

earth at the point of installation.

CC11..22..22

The encoder sensor must be mounted so that

it is electrically isolated from ground.

5 Volts

0 Volts

POWER

SUPPLY

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 66 67

Pas de commentaire

Microe Mercury II 6000V Manuel d'utilisateur Page 15