Microe MTE Series Manuel d'utilisateur télécharger pdf (Page 11)

Page 11

Sensor Head Installation (Side Mount Configuration)

MTE

™

Series Encoders

2.1 Loosen the Mounting

Fixture in the Y-axis.

2.3 Press down gently in

the Z-axis and tighten

the mounting fixture

screws.

2.2 Place shim between the bottom of the

Bracket Kit Adaptor and the top of the scale.

Mounting

fixture loose in

the Y-axis.

2.4 Carefully remove the shim by rotating it

off the scale with the shim’s handle.

Gently push

the mounting

fixture/Bracket

Kit and sensor

against the top

of the tape

scale in the

z-axis.

Z-Height (red)

spacer

Mounting fixture

screws

Verify Sensor Mounting Surface Height

Refer to the MTE interface drawing for detailed dimensions.

Use the Z-Height red spacer shim (1.00mm) to set the proper Z-height distance between the bottom

surface of the Side Mount Bracket Kit/MTE Sensor and the top of the scale.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Microe MTE Series Manuel d'utilisateur Page 11