Microe Mercury II 5000 Manuel d'utilisateur télécharger pdf (Page 52)

PurePrecision Laser Tape II Scale Installation

Mercury II PurePrecision Tape and Glass Scales

Installation Manual and Reference Guide

Step

Action

Install the PurePrecision Tape Scale along the remaining length of the mounting surface:

1. With one hand pull the adhesive backing progressively away from the scale while

the other hand slides evenly along the scale.

2. During the sliding motion, press the remaining tape on to the mounting surface

and pull the adhesive backing out of the way.

TIP: Maintain a gap of approximately 25 – 35mm (1 – 1½ inches) between the two

hands as you progress along the length of the tape scale.

Note: Be sure to keep the blue top protective film in place. Make sure that the tape

scale is tight against the “D” reference edge.

Once the tape has been installed, discard the adhesive backing.

Pull adhesive backing out of

the way during sliding. No

obstruction between tape

scale and mounting surface.

Sliding motion of finger

progressively along the

length of the tape

“D” reference edge as shown in

the encoder interface drawing

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 69 70

Pas de commentaire

Microe Mercury II 5000 Manuel d'utilisateur Page 52